Check and Adjust The Camber and Caster Angle For A Safety Drive
Adjustable Magnetic Gauge Tool is a convenient tool that do magnetic attach and measure the Camber and Caster angle on the wheel hub or brake disc. The main function of this gauge tool is allow adjustment to maintain correct wheel alignmentand prevent tire from getting untimely worn out.
It is also a useful tool to maintain the correct Camber settings after dismantling and re-assembling the suspension. Not only maintain correct alignment, it even save money by reducing tire wear with a simple correction to the camber and caster angle.
Magnetic gauge attaches to the wheel hub or brake disc
Easy to read and convenient to operate
Suitable for accurate checking of the castor and camber angle
Allows adjustment to maintain correct wheel alignment and even tire wear
Has a simple leveling adjustment from -5 degrees to 5 degrees
Allows to return the strut to the original camber position after dismantling and re-assembling the suspension
Allows to check the amount of camber change before re-installing
Time and money saving
How to use:
Remove the wheel alignment sensor (Clip tool), remove the tire;
Place the magnetic gauge carefully on the side of the wheel;
The water level was adjusted to zero;
Install the required positioning specific parts;
Use a special tool, with the degree of magnetic level gauge indication, adjust the positioning of the part to the desired measurement angle.
Retest with tool If there is a little deviation, just to fine-tune the vehicle. (Usually a slight deviation does not cause fault positioning)